LB Stainless Steel Oil Refrigerator Gear Pump

• Mesh Form: Internal Engaged
• Tooth Flank: Skew Tooth
• Tooth Curve: Involute
• Power: Electric
• Transport Package: Export Standred Wooden Case
• Trademark: HOFFWELL
• Model NO.: LB
• Origin: Cn
• HS Code: 841360299
• Production Capacity: 500sets/Month

Product Description

Lb Stainless Steel Oil Refrigerator Gear Pump

Capacity: 1.8-40 M3/H
Pressure: 2.5 Mpa
Temperature: 10-80 C
Motor Power: 0.55-11 Kw
Suction: 20-100 Mm
Speed: 960-1420
Voltage: 3 Phase/380 V/50 Hz
Explosion-Proof Grade: IP 55
Insulation Class: F

Outline

LB series freezer for gear pump is used to transport the viscosity at 200 ° E (1500mpa. S) following solid particles of impurities mechanical oil, turbine oil, lubricating properties and other media have a similar nature, the temperature is not higher than 120 C

Use

Transmitted in the transmission process may be used as the booster pump.
Used as a transport fuel systems, pressure, fuel injection pump.
In all industrial areas, can be used as a lubricating oil pump.

Scope

LB series freezer for fitness gear pump for conveying solid particles and fibers, non-corrosive, temperature no higher than 80 C, the viscosity of the oil or other liquids similar nature 5 ~ 1500 cSt lubricants.

Structural features
Gear adoption of new technologies with the international advanced level in the eighties pair of toothed arc sine curve. Compared with involute gear, the most prominent advantage is the process of gear teeth Gallery aggregate surface without sliding, so no tooth wear, running balance, no trapped fluid phenomena, low noise, long life, high efficiency. The pump is designed to get rid of the shackles of tradition, making use of the gear pump design, production on into a new area.
Pump has a differential pressure relief valve as overload protection, total reflux valve discharge pressure of 1.5 times the rated pump pressure. Also be allowed to be adjusted according to actual needs discharge pressure range. However, allowing the discharge need to be adjusted according to actual pressure range. However, the safety valve can not be reduced in this long-term work, when necessary, be installed in the pipeline.
The shaft end seal is designed in two forms, a mechanical seal, the other is a packing seal, can be determined according to the specific use and user requirements.